The module contains a SSD controller.
Disk formatting will be turned into FAT.
The module is provided with a USB A type connector (for the USB interface) and with a connector composed of 2x8 2.54 pitch swordsticks.
A bridge allows to select between serial or parallel interface.
The module works with a 12MHz cristal clock that is brought to 48 MHz inside the controller.
Supply voltage needed is 5V.
- SSD controller with USB interface
- Double disk interface : serial and parallel
- Supply voltage: 5V
1. Connector 1 standard USB connector
2. Connector 16 pins (2x8)
a. Pin-1 writing signal
b. Pin-2 Data bit 7
c. Pin-3 reading signal
d. Pin-4 Data bit 6
e. Pin-5 Operation enabling signal (CS)
f. Pin-6 Data bit 5
g. Pin-7 addressing signal
h. Pin-8 Data bit 4
i. Pin-9 interrupt signal
j. Pin-10 Data bit 3
k. Pin-11 supply
l. Pin-12 Data bit 2
m. Pin-13 GND
n. Pin-14 Data bit 1
o. Pin-15 GND
p. Pin-16 Data bit 0