The stepper motor driver is easy to use.
Compatible with all the digital systems with pulses from 0 to 5V (or from 0 to 3.3 V if the SJ2 is closed).
EasyDriver requires a supply voltage from 7V to 20V to supply the motor and can supply the stepper motor with any voltage.
The EasyDriver has a voltage regulator on the board for the digital interface that can be set either at 5V or at 3.3V.
Connect a 4-wire stepper motor to a microcontroller to have an high precision motoric-control.
EasyDriver drives the two-phase stepper motors or the motors wired like the 2-phase, as to say with 4,6 or 8 wires.
Driver A3967 microstepping
Bridges MS1 and MS2 to change the microstepping resolution to full, half, fourth and eighth of step (eighth for default)
Compatible with 4, 6 and 8 wires stepper motors with any supply voltage needed
Current control regulation from 150mA/phase to 750mA/phase
Supply voltage range from 7V to 20V. The Higher is voltage, the higher is the torque at high speed.